I had just gotten in to SiverFast 8 and was learning how to scan using the program and noticed that I could twist, the rectangle when I was setting up the scan, via the prescan, by just moving inside the image in a corner up or down. I not talking about the flip, rotate button, this was from inside the red rectangle.
Am I nuts.. no.. but how the heck did I get it to do that? I must have hit something!
Some of my old 35mm slides are angled within the holder and this would be a helpful.
V700 scanner.
Newbie: Se8 Twisting image...
-
- SilverFast Master
- Posts: 1430
- Joined: Mon Oct 22, 2007 9:33 am
Re: Newbie: Se8 Twisting image...
Hi there,
if you check the red scanning frame, towards the middle of each side you will find a semi-circle. Placing the mouse right above (the cursor changes) will allow you to free-rotate your scanning frame by any angle.
Cheers
if you check the red scanning frame, towards the middle of each side you will find a semi-circle. Placing the mouse right above (the cursor changes) will allow you to free-rotate your scanning frame by any angle.
Cheers
Alejandro Morales
LaserSoft Imaging
Media manager, Software testing
LaserSoft Imaging
Media manager, Software testing
-
- SilverFast Beginner
- Posts: 21
- Joined: Fri May 11, 2012 4:52 pm
- Scanner: epson v700
- SilverFast Product: SE
Re: Newbie: Se8 Twisting image...
ah thanks.. will give it a try in a few moments..
Return to “Imaging in general”
Who is online
Users browsing this forum: No registered users and 1 guest