Page 2 of 2
Re: Kodachrome targets
PostPosted: Tue Feb 21, 2012 8:40 am
by LSI_Morales
Hi Peter
It seems this is a normal slide, I too believe this can be handled by the normal slide mode in SilverFast.
I'm glad things are clear now.
Kind regards
Re: Kodachrome targets
PostPosted: Wed Feb 22, 2012 2:45 am
by degrub
check to see if the slide had varnish on it. i think that is too late to have had that treatment, though.
Re: Kodachrome targets
PostPosted: Fri Jan 10, 2014 8:24 pm
by KeithTalbot
Regarding the comment about Silverfast having the last few rolls of Kodachrome earlier in the thread, I have an unopened, unused roll of Kodachrome 200 I am happy to donate to you if it is of any use.
Obviously, the "expiry date" on the pack was years ago, but if it is of any use I don't mind posting it to you.
(I would have sent an email directly but there seems to be no email contact address)
Regards
Re: Kodachrome targets
PostPosted: Thu Jan 16, 2014 5:14 pm
by LSI_Ketelhohn
Dear customer,
Thank you for the offer.
However it is not just the material itself.
Kodachrome requires a very special development technique.
When Kodak went out of business all labs which could develop this film were closed.
kind regards,
Arne Ketelhohn.