Epson V700 Scanner

[telabs]

White areas of the scan are not white, they have a slight blue/grey cast when printed with my Epson R2000 printer.

What do I need to do?

Thanks

[LSI_Morales]

Hi telabs

You will then have to set the white point using the pipette.

Cheers

[telabs]

Thanks, but I don't know what that is. I can't find it in the booklet. What does it look like? Is there a video?

[telabs]

Is there a way to adjust only the density of the black? I'm happy with the scan but the density of the black when printed is too light. I can't see any way other than to change the brightness, but that affects the whole image. I just wanna make the black denser.

[LSI_Morales]

Hi there

Thanks, but I don't know what that is. I can't find it in the booklet. What does it look like? Is there a video?

This is the pipette tool:

Pipette.png (22.35 KiB) Viewed 1084 times

According to the place of the button you choose, it allows you to set the white, grey or black points.

Is there a way to adjust only the density of the black? I'm happy with the scan but the density of the black when printed is too light. I can't see any way other than to change the brightness, but that affects the whole image. I just wanna make the black denser.

You can use the black pipette to set the black point

or you can set it adjusting the shadows in the histogram, you can also set midtones and highlights using the triangles below the graph:

Screen shot 2011-07-27 at 9.38.32 AM.png (30.8 KiB) Viewed 1084 times

Cheers