LaserSoft Imaging

Hello, I just purchased a Plustek OpticFilm 7600i. I have calibrated with the IT8 calibration slide but need to know if this calibration setting is reset upon turning the unit off, each time. If so, is there any way to make the IT8 slide calibration the permanent setting for this unit? I'm just learning how to use this great film scanner and don't spend hours and hours scanning hundreds of slides just yet.

Thanks for your help, in advance.

Darren

Hi Darren

Green1224 wrote: I have calibrated with the IT8 calibration slide but need to know if this calibration setting is reset upon turning the unit off, each time. If so, is there any way to make the IT8 slide calibration the permanent setting for this unit?

The IT8 calibration will remain even after turning the unit off.

Cheers