Why do my scans come out so bad?
PostPosted: Mon May 22, 2017 5:09 pm
Hi,
I have been using a Plustek 8200ai to scan some 35mm negative colour films. I use Negafix and iSRD on each frame scanning at 2600dpi. For some reason in every frame I seem to get a lot of artefacts and noise. To see if it was my scanning technique or just the film I had the same frames scanned at my local shop (be it at a much lower resolution, but same size) and the picture is much cleaner. Any ideas what I am doing wrong? I have attached a portion of the same frame as an example. this section is out of focus but demonstrates what I mean about the overall clarity...
The second photo was scanned at a much higher resolution on the 8200ai and is full of white dots?
I have been using a Plustek 8200ai to scan some 35mm negative colour films. I use Negafix and iSRD on each frame scanning at 2600dpi. For some reason in every frame I seem to get a lot of artefacts and noise. To see if it was my scanning technique or just the film I had the same frames scanned at my local shop (be it at a much lower resolution, but same size) and the picture is much cleaner. Any ideas what I am doing wrong? I have attached a portion of the same frame as an example. this section is out of focus but demonstrates what I mean about the overall clarity...
- Screenshot 2017-05-22 17.04.11.jpg (114.62 KiB) Viewed 2689 times
- Screenshot 2017-05-22 17.04.53.jpg (185.23 KiB) Viewed 2689 times