Bug: Scan the two sequent slides in Batch in brandnew releas
PostPosted: Fri Oct 24, 2014 5:30 pm
Hello LSI,
I updated the SilverFast to current release 8.2.0r1 and found the following issue or bug:
If you scan in batch mode with Multiple Exposure set to "on" the first slide will be scanned as usual.
From the second slide on: each scan is feeded by a new slide.
E.g. Slide 2 in first run of ME Scan , and Slide 3 in second run of ME Scan (RGB and IR), and so on...
I reproduced it in one of my test virtual machines, and compared it to previous version 8.0.1r54, where everything
went well.
My environment: Windows 7 - 64 bit
Silver Fast Nikon LS 5000ED / Super Coolscan 5000 ED + HDR 8.2.0r1
Slide Feeder SF210
I updated the SilverFast to current release 8.2.0r1 and found the following issue or bug:
If you scan in batch mode with Multiple Exposure set to "on" the first slide will be scanned as usual.
From the second slide on: each scan is feeded by a new slide.
E.g. Slide 2 in first run of ME Scan , and Slide 3 in second run of ME Scan (RGB and IR), and so on...
I reproduced it in one of my test virtual machines, and compared it to previous version 8.0.1r54, where everything
went well.
My environment: Windows 7 - 64 bit
Silver Fast Nikon LS 5000ED / Super Coolscan 5000 ED + HDR 8.2.0r1
Slide Feeder SF210