LaserSoft Imaging

Calibraton with IT-8 Kodachrome target was successful and is set in the preferences/options dialog, but clicking on Kodachrome to choose this mode for scanning does not work. 'Frames' is always active, Kodachrome not selectable. Is it not necessary to chose Kodachrome mode when Kodachrome profile is set in the preferences/options dialog?

Dear Mr Wiler,

The Kodachrome profile automatically actives the correct ICC profile.
And the IT8 calibration automatically selects the created profile for this mode.

But your screenshot shows Kodachrome to be active.
It does not seem to be greyed out or un selectable.
I am not sure I understand your issue correctly.

Kind regards,
Arne Ketelhohn.

Dear Arne Ketelhohn

Thanks for your answer. I missinterpreted the "flat" icon as not active, because other icons were selectable as it it the case with "Rahmen", framed by a red line. I do understand the logic now. If not selectable this means it is (already) active.

Yours
Thomas Leu