LaserSoft Imaging

Hi.

In the settings, "automatic" tab, there are two slider for automatic adjustment to dark tones and light tones.
When I move the values​​, the image displayed is well corrected.
But when I do batch scan, these sliders are useless as the last switch of this tab is active or not (titled in french "Numerisation par lot avec automatique", wich doesn't mean nothing...).

How to use its automatic corrections?
Is there another switch for activate this automatic corrections ?

Regards

Dear customer,

Are you using the latest release of SilverFast (8.0.1r28)?

I have just tested the auto tone adjustment and it worked for both batch and normal scans.

If you continue to have issues I will forward your posting to our support system for further analysis.

kind regards,
Arne Ketelhohn.

Dear customer,

I have forwarded your post to our support system as I will need some screenshots to understand your issue better.


kind regards,
Arne Ketelhohn.

Thanks Arne.