Page 1 of 1
v700 and black dots on scans
PostPosted: Sat Apr 21, 2012 4:44 am
by beichh4046
I just got the V700 and all my scans have black specks in the same pattern on all scans. These are not dust specks. I have sharpening set to none. These are b&w negatives that I am scanning. I'm using the SE 6 that came with the scanner.
Any ideas what is causing this problem?
v700 and Microtek i900 comparison scan
PostPosted: Sun Apr 22, 2012 4:42 pm
by beichh4046
- Here is the Epson scan showing black dots all over the place as well as scratches
- epson-scan.jpg (143.18 KiB) Viewed 2153 times
I decided to upgrade the Microtek i900 I was using because vertical lines kept showing up that were time consuming to edit. But, I have black specks showing up all over the scan with the v700. I have posted two crops to show the difference. The v700 is brand new.
- Here is the Microtek scan. Much better scan
- microtek-scan.jpg (244.17 KiB) Viewed 2153 times
Re: v700 and Microtek i900 comparison scan
PostPosted: Mon Apr 23, 2012 8:21 am
by LSI_Morales
Hi there,
It looks like those specks are either on the film emulsion or on the scanner surface.
Kind regards