LaserSoft Imaging

Hi


As I am always scanning 8 frames at a time, I need to find out how I can use MEX with the JobManager. Initial tests suggest that the JobManager does not call up MEX, so I probably need to set this up differently. Can you help?

BR,
Rainer

Dear Rainer,

If you are using a flatbed scanner you just have to activate Multi-Exposure on every frame you have set on your flatbed.
If you are working with a dedicated FilmScanner, you will have to copy the settings from one frame to all other (you can of course select which settings should be copied and which shouldn't). This can be done with the JobManager.

Please check the following documents:

http://www.silverfast.com/download/docu/ch6specialfunctions,completechapter_en_2006-11-27.pdf
http://www.silverfast.com/download/docu/ch6.12jobmanager_en_2006-06-19.pdf
http://www.silverfast.com/download/docu/jobmanageraddendum_en_2006-06-19.pdf

Cheers

hi

unfortunately i have found out that the mex is not available with negatives, so i will have to wait until i have started with slides. pity this escaped my notice. i will investigate, as i had the same experience with dust-removal.

br
rainer

Hi Rainer,

Could you please make a bit clearer what you mean by:

r-heim wrote:i have found out that the mex is not available with negatives

Don't you have this option present in the preview window? or you mean in the JobManager?

I believe as long as you are scanning transparencies, Multi-Exposure should be available regardless of positive or negative materials.

Cheers