LaserSoft Imaging

I am not sure if this has been discussed before but I am finding that the crop I perform in the preview box is not consistant with the finished image. After my preview scan I will normally edge in from the borders with the cropping tool to make sure I don't have any white borders showing. I will then scan the slide. However, after my scan completes and opens in Photoshop 7 I find that the crop has shifted over to the left. The result of this is that I see a white border on the right edge. Not a major problem but certainly frustrating after taking the time to set the controls only to find that you cannot use the image because of an incorrect crop. I have the most recent version of SE 6. Am I doing something wrong in my previewing?

Dear platolover

could you please post a screenshot of the preview and the scanned image so that we can see what you see.
Also, please tell us what scanner and operating system you are using.

Thanks very much in advance for your kind assistance.