LaserSoft Imaging

Over the last couple of days I have been experimenting with my new Epson v800 and SilverFast SE 8.

I read somewhere (cannot find where now) that the slide tray height adjustment needs to be at its lowest position to get the best results from iSRD. Is this true (since I cannot confirm what I read)?

On a side note the literature indicates iSRD has trouble with Kodachrome slides. If the slide is Kodachrome will that be indicated on the slide frame? Otherwise how would one know?

Dear customer,

The hight of the holder should be set in a way, that it gives the sharpest results.
So far we have found few occasions where it was necessary to set it to a setting other than the standard hight.

Certain Kodachrome emulsions are very dense and partially or totally block the scanners infrared channel. This can result in wrong areas being corrected or artifacts in the image.
Most often Kodachrome slides can be identified by their paper frame.

Kind regards,
Arne.

What is standard height? I thought I had read that it should be in the next to the lowest. I did run a few tests and found no perceptible difference in focus between settings. Thanks for the info on Kodachrome slides.

Yes it is one above the lowest. It has a triangular marking instead of a rectangular one.

Kind regards,
Arne