LaserSoft Imaging

PostPosted: **Thu Feb 04, 2016 11:48 pm**

This is my first post and I am enjoying developing and scanning my own negatives.

I am scanning 6x6 negatives using SilverFast Ai Studio (the latest version) with the Epson V850's 6x6 negative holder (the one with one strip). I would like to perform the automatic frame detection (IFF*). But I cannot find the option for 6x6 negative. I tried different options such as 6x6 slide and all frames but frames found all seem to be clipped.

I must be doing something wrong but cannot figure out what. You advise is greatly appreciated.

Tom

PostPosted: **Fri Feb 12, 2016 5:30 pm**

Dear Tom,

Are you using the latest update?

Kind regards,
Arne Ketelhohn.

PostPosted: **Sat Feb 13, 2016 5:55 pm**

Just checked and it shows I am using the latest version 8.8.0r2. Please see the screenshots.

Thanks,

Tom

: Showing the connected Epson 850; 1.png (202.33 KiB) Viewed 892 times

: Show version number; 2.png (208.25 KiB) Viewed 892 times

: Which auto frame detection option to select?; 3.png (216.71 KiB) Viewed 892 times

PostPosted: **Wed Feb 17, 2016 10:06 am**

Dear Tom,

The 6cm holder option should be the right one for this setup.

Kind regards,
Arne Ketelhohn.

LaserSoft Imaging

Auto frame detection for 6x6 negative using EPSON 850 holder

Auto frame detection for 6x6 negative using EPSON 850 holder

Re: Auto frame detection for 6x6 negative using EPSON 850 ho

Re: Auto frame detection for 6x6 negative using EPSON 850 ho

Re: Auto frame detection for 6x6 negative using EPSON 850 ho