LaserSoft Imaging

Hi!
I've Version 4.2.1 of Silverfast for my Scanner. I use WinME.
I bought a new Document feeder and installed it ontop of the Scanner.
It works only with the Epson twain drivers, not with Silverfast.
I changed the settings to "Dokumenteneinzug" (Document feeder), but if i try to scan, I get the Message:

"You try to scan in reflective mode but the transperancy unit is switched on. Please turn it off and press ok."

But there is only the Document feeder plugged in at the backside of the GT 7000. How can I use the ADF with Silverfast ? Any Ideas ?
C-U
Kai

Unfortunately the ADF- unit is not supported by Silverfast. The setting in the software you're referring to is a little bit misleading- it does not adress an automatic document feeder- it's merelu used for "batch scanning". In this mode, the software- kind of- "emulates" an ADF. The actual ADF unit is not supported...


***
and god is on your side
dividing sparrows from the nightingales....

Hello!
Thank you for your Message.

Isn't the ADF supported in the latest Version of Silverfast, too?
Greetings from Germany.



watching all the time
dividing fiction from reality