LaserSoft Imaging

Hi Ian,

As you know from the coversation yesterday I have, well I think I have correctly installed and calibrated my SprintScan 4000's IT8 calibration files.

During the IT8 calibration it asked me to install the IT8 file. I selected this from my SilverFast CD.

My tranie has the following information on it:- IT8. 7/1-1993 1999:10. C Roes

I slected the following file form the CD, because I think its the closest match:-

IT8 Refeence File>C Roes>Dia 35mm>TK1 199910C2.

Have I selected the correctly matched file?

Regards

Mike Jones

Mike,

that IS the correct file for your IT8. although the wroding on the tranny is normally:

IT8.7/1-1993 1999: T2X C-ROES

Ian

<font size=-1>[ This Message was edited by: ilyons on 2002-01-08 01:44 ]</font>

Ian,

Again thanks for guideance and help, I look forward to producing some high quality prints.

Regards

Mike Jones