LaserSoft Imaging

I just upgraded my Silverfast and now get fantastic negative scans but every time I try and use the JM I get as far as placeing my images in the JM window. As soon as I try and do anything else, PS gives me an error (unspecified), and shuts down. Pg. 209 of the manual talks about a source file error but I don't think I've gotten that far yet.

I'm running PS 6 with a Sprintscan 120,Windows ME and tons of memory. Thanx

<font size=-1>[ This Message was edited by: Yaqitwn on 2001-11-13 17:04 ]</font>

Dear Yakitwn,
did you install your upgrade over your old installation of SilverFast?
you should not do so. Please delete SilverFast completely (Start > settings > control panel > software) and than install just the new SilverFast once.