LaserSoft Imaging

In checking for updates, I no longer see the SS4000+ noted in the version 6 upgrades?

Is this a mistake, or is the 4000+ no longer supported?

why not just download the file and see?

just being careful. There has always been a specific 4000+ download, and I found it strange that it is now gone...

Dear Dave,

did you try the demo? Did you encounter any problem?

Thomas

Hi Tom,

I'm a silverfast 6.0 user....and up to a week or two ago, there was a separate update for the 4000+ and firewire. Now, it list only the 4000 as scsi.

If this is an intentional combo of software, perhaps the link should state it's for both the 4000 and scsi and 4000+ and firewire.


I would appreciate clarification,

thanks

David

Dear Dave,

the plug-in for the SS4000 is the same one as for the SS4000+, and it works : you can download it. The corresponding webpage will be corrected.

Thanks for the info.

Thomas