Page 1 of 1
Problems with Ilford HP5 scans
PostPosted: Sat Oct 05, 2002 12:09 am
by bear
I never scan B+W negs. The two times I have I have not been successful. On these current 35MM negatives I find the contrast very high ,poor shadow detail and washed out highlights. The negatives may be a bit overexposed but I can not seem to bring everything into line. I am using NegFix 5.5 and a Sprintscan 120 on a MAC G4 . Any suggestions?
mark
Ilford HP Scans overexposed in NegaFix
PostPosted: Fri Oct 25, 2002 5:08 am
by President_LSI
Ilford HP Scans overexposed in NegaFix
Go to the
NegaFix Expert dialog and select Curves. If the upper right has a curve with a bump, use the edit mode to make the section of the curve linear. This will reduce the contrast and decrease the overexposure!
How to use the
negaFix expert dialog is explained in the SilverFast full
manual (or
PDF).
PostPosted: Fri Oct 25, 2002 2:46 pm
by bear
Thanks
mark
PostPosted: Wed Nov 13, 2002 3:01 pm
by bear
Still having the same problem this time with Kodak Potra B+W film. I tried the curves but I am not having much luck. Contrast is the probem,setting the white point and black point does not help. Which film channel should I be using for B+W film?
Mark
PostPosted: Wed Nov 13, 2002 6:43 pm
by LSI_Belli
Dear Bear!
you can maybe have a look at some tips given in the forum, for example:
viewtopic.php?t=190
Good luck
Thomas