silverfast AI 8.8 crashes when returning scan to host Progra
PostPosted: Sat Feb 20, 2016 1:28 am
Hi: I have a fresh install of Windows 10 (64 bit) on a new machine. I installed Silverfast AI studio Version 8.8.2 (64 bit version) for my Epson perfection 4870 scanner (USB connection). When I run Siverfast as a stand alone program all seems to work well including the saving of the final file. However when I use a program to call the Twain driver to acquire a scan from the Silverfast Twain driver, the scan transfer fails. All goes well with silverfast until the final step when it completes its scan. Siverfast stops working and Windows 10 closes Silverfast down. (I am guessing this is at the transfer from to silverfast to the host program.) This leaves the calling program frozen and I have to close it down. I have tried this with the Epson Twain driver and the Epson WIA Twain drivers and all works well. Only the Silverfast Twain driver fails. I have noted that the Silverfast Twain driver is listed as "Silverfast TWAIN 1.0(32-32)", guess I was expecting a 64 somewhere in the number. I have tried scanning a Black and white image scan of a post-it at low resolution (Web at smallest size) and it did not crash, it just ran for a longtime (Hours) in save mode after scanning and never finished, seemed to hang at 29%. Has anybody else had this problem? Any suggestions?
Gmoss
Gmoss