Page 1 of 1
PostPosted: Sat May 18, 2002 12:54 am
by geoff waugh photos
In the pre-headache days when my Silverfast worked in almost perfect harmony with my LS-2000, I found it was ok with the MA-20 single tranny adapter but the SA-20 film strip adapter didn't function at all. Is this normal or am (was) I getting half the deal (actually a third counting the misbehaving SF-200) ?
<font size=-1>[ This Message was edited by: geoff waugh photos on 2002-05-18 01:55 ]</font>
PostPosted: Wed May 29, 2002 10:07 am
by LSI_Support
On 2002-05-18 01:54, geoff waugh photos wrote:
In the pre-headache days when my Silverfast worked in almost perfect harmony with my LS-2000, I found it was ok with the MA-20 single tranny adapter but the SA-20 film strip adapter didn't function at all. Is this normal or am (was) I getting half the deal (actually a third counting the misbehaving SF-200) ?
<font size=-1>[ This Message was edited by: geoff waugh photos on 2002-05-18 01:55 ]</font>
The SA-20 works fine, did you check our FAQ sites?
PostPosted: Sat Jun 01, 2002 11:41 am
by geoff waugh photos
Well mine doesn't! I get two error warnings. The first is "film adapter not found' followed by 'MAID library not found'. I have tried installing the SA-20 first and then turning everything on, hot swapping etc but to no avail. Perhaps I have to wait until another user finds the solution and posts it here. Imagine i f my new car was run on a similar basis!
PostPosted: Mon Jun 03, 2002 7:17 am
by LSI_Flyvbjerg
Geoff.
Please contact the support team diretly at:
support@silverfast.de. You will get quicker respones than trough the forum.
Eric.
PostPosted: Sat Jun 08, 2002 12:14 pm
by geoff waugh photos
He's right you know! Cheers Eric and cheers Clovis. I am fully functioning again.