Page 1 of 1
I would like to buy a Calibration targets for 9000ed
PostPosted: Thu Feb 18, 2010 10:36 pm
by DD70DanielW
Hi,
I would like to buy Calibration targets for my 9000ed, but I'm a bit confuse about which size shall I go for...
Because I'm using 35mm, 6x6 & 6x9 films size all the time, so does it mean I need to buy all the size targets? Or I can just buy 1 size target for all?
Hope anyone can help me?
Many thanks!
DanielW
Re: I would like to buy a Calibration targets for 9000ed
PostPosted: Fri Feb 19, 2010 10:03 am
by LSI_Ketelhohn
Dear DanielW,
You only need one calibration target.
The created profile is valid for all sizes and filmholders used.
Larger targets are more resistant and more convenient in regards to handling.
kind regards,
Arne Ketelhohn.
Re: I would like to buy a Calibration targets for 9000ed
PostPosted: Fri Feb 19, 2010 6:45 pm
by DD70DanielW
Dear Arne Ketelhohn,
Many thanks for yr kindly help~ I'm more clear now~
So that means i just buy 6x7cm FUJI & KODAK transparency each 1 for 9000ed !!
And 1 more question is If i buy these 2 targets so also can use for negative? Or just fit for silde only?
Normally i will use below films
silde :
FUJI 50rvp 100rvp Provia100 astia100
KODAK Ektachrome e100vs e100g
negative :
KODAK 100uc 400uc ektar100 160vs 160nc
Regards,
DanielW
Re: I would like to buy a Calibration targets for 9000ed
PostPosted: Mon Feb 22, 2010 5:30 pm
by LSI_Ketelhohn
Dear DanielW,
the calibration is only used for slides/positives.
For negative film we use special profiles which are adapted to the individual filmtype.
kind regards
Arne Ketelhohn