LaserSoft Imaging

Hi,

I post process using LighRoom and the way LR adjsutments are designed it would be great if I could ivert my negative into a positive during the scanning process so that I have a B&W ppositive .TIF file to adjust in LR. How do I do this when scanning using SF AI?

Dear hassiman,

please choose Negative in the Pos/Neg popup to activate NegaFix,
and try the NegaFix-profile that has been measured for your film type,
or the general "Monochrome" profile, or the "Standard" profile.
You even try the "Linear" profile, or setup your own profile adjusted to your special negatives.
The best choice depends on the actual behaviour of your negatives.

Best regards
Martin