LaserSoft Imaging

Hi,

I seem to be having in intermittent issue when creating a profile for my Nikon LS-50 (CoolScan V). I am using SilverFast Studio IT8 v6.5.0r8a.

To run the calibration, I have been following a procedure on <http> to set SilverFast so color management is temporarily disabled. Basically, I set everything to "none," create a profile, point to this profile, and set color management back to ColorSync for Input -> Internal and Internal -> Monitor, and to RGB for Internal -> Output.

I have had difficulty in setting everything back. I will sometimes get an error saying that I must enter a setting for Internal (even though it is already selected using the profile I just created) because I am using using ColorSync for Input -> Internal.

I sometimes create another new profile and am choose my newly-created scanner profile. Other times I can't choose my new profile, in which case I will select one of the stock profiles for the CoolScan V.

I am sometimes very cautious in deciding whether to go with a new update for fear that CMS will be "broken."

Does anyone have any similar issues?



Thanks,

Rocky

Dear rapope,

sounds strange. Are you working in positive mode?

Please send me one of your generated profiles as a private message so that I can inspect it.

Best regards
Martin

Martin,

I will have to try to generate another one which will hopefully generate an error. I will get to try this again on Monday.


Thanks in advance for your assistance,

Rocky