Page 1 of 1
Version: 6.0.1r35 numbering does not work
PostPosted: Sat Dec 14, 2002 10:03 am
by MJunak
When batch scanning I try to change the numbering for the images but it always reverts back to the original number. When will this be fixed?
PostPosted: Sun Dec 15, 2002 5:50 pm
by Gregory C
are you referring to batch scanning or Job Manager scanning?
if you're using the Job Manager, batch scan numbers do nothing. all of the numbering is controlled by the name set during addition of the images to the queue, or thereafter by manual editing while in Edit mode (the pen button pressed down).
PostPosted: Mon Dec 16, 2002 8:12 am
by MJunak
I am simply batch scanning. When I specify a filename (eg. MJ_5345) as the start no. it reverts to MJ_0017 or whatever number that was last scanned. I am using this on OSX 10.2.2 from within Photoshop 7. Silverfast support said it would be fixed in version 6.0.1r35
PostPosted: Mon Dec 16, 2002 11:48 am
by LSI_Muenier
There seems to be a mistyping.
Checking the sources of SilverFast, we find the fix (neccessary for OSX only) to be present since version 6.0.1r39.
I'm about to send you a current SilverFast NikonMaid version to your email address.
Martin