LaserSoft Imaging

Hello,
using AI Studio 8.0.1.r19 with a Nikon 9000ED and a filmholder 896S (120/220 film) I am not sure , whether I have a problem with the "adf-scans with autoframe" option (please see the screenshot). "Overview" correctly shows all four 6x4,5 bw negatives of one filmstrip.
If I start the adf-scan I see the message "connected" followed by a prescan -> autoframe -> final scan for every negative. That is, what I am expecting. But the result of the auto-frame operation is not satisfying. It finds not the real negative (eg. marked by blue line in the screenshot), Instead it shows always the maximum frame size. The same behaviour is seen when using the frame-function "find frame" -> "all frames". Is this a bug or do I make some mistake? Can you help?
Best wishes Werner

Dear Werner,

The autoframe detection relies on clear contrast values at the image border.
Especially on B&W images this can sometimes fail.
This function is currently being improved as well.

kind regards,
Arne Ketelhohn.

Dear Arne,
thank you for your help. Is it possible to get some information with the release of that improvement for testing it again?
Best regards
Werner

Dear Werner,

I will try to think about posting here to inform you.

kind regards,
Arne Ketelhohn.

Hello Arne,

The autoframe detection relies on clear contrast values at the image border.
Especially on B&W images this can sometimes fail.
This function is currently being improved as well.

Do you have new informations regarding this issue? Is there any change/improvement until current version 8.0.1.r24 ?
Kind regards
Werner

Dear Werner,

No, not yet, this is still being worked on.

kind regards,
Arne Ketelhohn.