Autofocus
PostPosted: Thu Jul 07, 2011 1:30 pm
To enable autofocus manually it's necessary to click the focus button, select "Autofocus manually", after which you have to place the cursor to an appropriate place in the pre-scanned image.
Then you start the scan.
When you enter a new scan job, you have to do this again. You cannot simply shift the autofocus point to a new location.
Am I missing something, is there a quicker way to do this? A shortcut for instance?
thanx
Then you start the scan.
When you enter a new scan job, you have to do this again. You cannot simply shift the autofocus point to a new location.
Am I missing something, is there a quicker way to do this? A shortcut for instance?
thanx