LaserSoft Imaging

I have a middle format film strip and I have made scan selections for each picture from the film, with differing brightness settings. It would be useful to be able to now have the program silverfast ai scan all of them, one after the other. However, I havent figured out how to do this. So instead I have to scan one into photoshop, then the program closes, then I have to go to Import and scan the next, etc, etc. So, where is the 'scan all' button?

thanks

Dear cyphunk,

I would suggest you use the SilverFast launcher to start the stand alone application scanning into a folder.
There you can either use batch scanning to process all frames or (if you own SilverFast Ai) the JobManager.
Batch scanning scans all images with the current frame settings.
The JobManager allows for individual settings for each frame.
It is not advisable to do this from the Photoshop import. Photoshop would open all batch-/JobManager scans at the same which requires a vast amount of memory.

kind regards
Arne Ketelhohn

thanks!

your welcome

how good the performance of this application?
what are the specs needed?
does it require higher specs to have this software?

Dear forumday4,

Here you can find a list of our features:
http://www.silverfast.com/highlights/short/en.html
http://www.silverfast.com/show/highlights/en.html

Our System requirements are listed here:
http://www.silverfast.com/show/sysreq/en.html


kind regards
Arne Ketelhohn

LSI_Ketelhohn wrote:Dear forumday4,

Here you can find a list of our features:
http://www.silverfast.com/highlights/short/en.html
http://www.silverfast.com/show/highlights/en.html

Our System requirements are listed here:
http://www.silverfast.com/show/sysreq/en.html


kind regards
Arne Ketelhohn

Thank you so much Arne for providing the lists that answers to my question...

my pleasure


kind regards
Arne ketelhohn