LaserSoft Imaging

Hi all,

I've got a question regarding the auto-frame option in Silverfast Ai Studio 6.6 and Silverfast HDR Studio 6.6.

By default the auto-frame (35 mm slides in my case) is automatically resized and rotated to fit the actual image.
Since rotation isn't lossless I would prefer to only automatically resize the frame and not to rotate it. Is there a possibility for this?

Furthermore (but not as important as the request above) is there an option to configure the auto-frame so it touches the physical frame of the slide from the inside? I know there's an option to shrink the auto-frame by a given percentage, but even 1 % (which is the minimum) allready cut's away decent amounts of the image.

For clarity I've attached a sketch of what I mean:
- first image: current behaviour (auto-resize and auto-rotate)
- second image: only auto-resize, current behaviour "touch from outside", frame could be cropped by "shrink frame"-setting (first part of my request)
- third image: only auto-resize, suggested behaviour "touch from inside" (second part of my request)

Regards
Eduard

Dear Eduard,

You can not switch off the auto rotation feature.
But you can straighten a frame by holding the shift key and then grabbing the rotation handel and rotating the frame.


kind regards,
Arne Ketelhohn.