LaserSoft Imaging

Epson V700 Silverfast SE Version 6.6 - batch scanning parameters

Hi - I have been batch scanning 35mm film using the Epson V700 and Silverfast SE Version 6.6. I see that I can change the default scanning parameters for each frame of film individually but I can find no way to set scanning parameters for the entire batch without entering the parameters separately for each frame. Is there a way in SE Version 6.6 of setting the parameters once for the entire batch? Thanks

Dear customer.

you can either prepare settings in a single frame and then copy that frame by pressing alt and clicking into an empty part of the scan area.

Else the job-manager is capable of copying frame settings.
- move all frames to the job-manager
- select the first frame.
- make all changes and save them by de-selecting the frame.
- select the changed frame again.
- press the select all button in the job-manager.
- press the copy parameters button in the job manager.
- select the parameters to be used in all frames.
- start the scan-job.

kind regards
Arne Ketelhohn

Thanks for this, but is the job-manager available in the SE edition?

Dear Customer,

the JobManager is included in SilverFast Ai & Ai Studio
As well as with the bigger versions of SilverFast DC and all of the SilverFast HDR Versions.

Here is a feature comparison
http://www.silverfast.com/comparison/en.html