LaserSoft Imaging

I am a beginner user and probably just have not done something simple. I am using a Microtek i900 flatbed and scanning 35mm slides. I have Windows XP. After scanning an overview I make edits to color balance etc. to the images. I then scan them using the Job Manager to a file. When I look at the files created, none of my edits are there. They are just the images that were scanned initially without any of my corrections. Why is this? What have I not done?

Dear dhubka,

in what scan mode are you scanning please not that if you are scanning in HDR Mode there are no changes made to the Scan.
If this is not the case you should directly contact our Support through our Support Assistent so we can sort it aout with you.

best regards,

Thomas Lübker
Software Support Specialist
LaserSoft Imaging AG