Page 1 of 1
Cannot run Silverfast plug-in for PS CS3
PostPosted: Wed Jul 16, 2008 7:27 pm
by macmark
I am running Silverfast v6.4.4r7a on an Apple Macintosh running OS 10.4.11. I can run SF as a stand alone application, but cannot run it as a Plug-in to Photoshop CS3. I found on the support site that I need Silverfast v6.5.5r3 to run it as a PS CS3 Plug-in. But the most current Download version is the one I am running. How do I get v6.5.5r3? Thanks for any suggestions.
Mark W.
Re: Cannot run Silverfast plug-in for PS CS3
PostPosted: Fri Jul 18, 2008 10:17 am
by Administrator
Dear Mark W.
you need to
purchase the
upgrade. For 6.4 to 6.5 it's not free.
Re: Cannot run Silverfast plug-in for PS CS3
PostPosted: Fri Jul 18, 2008 4:07 pm
by macmark
I purchased the upgrade, downloaded and installed it. I can run the newer version as a stand alone application, but I cannot run it as a PS CS3 plug-in. Suggestions would be appreciated.
Mark W.
Re: Cannot run Silverfast plug-in for PS CS3
PostPosted: Tue Jul 22, 2008 8:39 am
by LSI_Luebker
Dear Mark,
as you had SilverFast 6 installed before it could be connected to the "prefs" please delete them
the are located in /User Folder/library/prefferences/LaserSoft Imaging .
This should help, if you still experience problems it would be best to contact our Tech Support directly via the Support Assistent.
best regards,
Thomas Lübker
- LSI Software Support Specialist -
Re: Cannot run Silverfast plug-in for PS CS3
PostPosted: Tue Jul 22, 2008 11:20 am
by macmark
Hi Thomas
That fixed the problem and v6 now works perfectly. Thanks for the help!
Mark W.