LaserSoft Imaging

I am using a flatbed that allows me to scan 30 negatives per batch.

Typically I am putting 24+ frames on the flatbed per batch.

How do I tell the software that all frames are Fuji 400 Superior? That all frames are 2800 dpi? etc.

Basically I want the scanner to recognize all the frames are the same from the start.

Currently I have to change the basic settings 24 times ( 1 for each frame).

Is there a faster way to do this?

Dear Tim,

you have at least three possibilities:
- save your preferred frame parameters in the "Setting" popup you find in the "Frame" panel of the main dalog and choose it from there for new frames when activating them
- save as desribed above and choose this Setting in the "Options" dialog's "General" panel's under "Default Settings" - then every new scan frame will get your saved frame parameters
- you may also "clone" a scan frame together with its frame parameters: please press the Alt-Key and hold it down in the following process, where you first click into the exisiting frame on the preview and then click anywhere on the preview to create a cloned scan frame (and click again and again ... if you need more frames), and finally release the Alt-Key.

Best regards
Martin