LaserSoft Imaging

"Could not complete import command because
of a problem with the acquisition module
interface"


I get this message quite often; it completely disrupts my work. What do you think this is caused by? The message almost always appears during the descreening process or later.

Jinx wrote:"Could not complete import command because
of a problem with the acquisition module
interface"


I get this message quite often; it completely disrupts my work. What do you think this is caused by? The message almost always appears during the descreening process or later.

I get this too. It sometimes goes away if I restart the computer, but sometimes not. Much more frequent since I installed 6.5.0r4(Epson SE). Photoshop version.