LaserSoft Imaging

Hi

I have silverfast 6, which i am using on a Powrlook 3000. My computer is a Apple G5, running OSx 10.4. (Tiger).

(1) When go into cms, and set my calibration input-internal to colorsync, it works for a while then it goes back to none. Why is it doing this?

(2) I have updated to 6.4, but there appears to be no differences.

(3) What are best settings to use when scanning 35mm transparencies.

Please Help

Dear Mattias

please don't hesitate to contact support: http://www.silverfast.com/problemreport/en.html
How to help support staff to help you: http://www.silverfast.com/faq/1058/en.html

Please note that the purpose of the imaging forum is not to provide personal support. It is intended to serve as a platform for imaging professionals for exchange of experience and communicating ideas [ viewtopic.php?p=9763&highlight=9763 ].
Thank you in anticipation of your kind co-operation.

Best regards
Sonny Noack
- Manager Technical Support, LaserSoft Imaging AG -