LaserSoft Imaging

I have the "Set Parameters for Scan-Frame" box checked in the Pref for ScanPilot.

I initiate the pre-scan using ScanPilot. The second step pauses to allow me to adjust the size of the scan which is great . However, then an annoying dialog box pops ups titled "Note" with the contents reading "After closing this alert, draw your desired scan frame.......". Is there a way to make this dialog box go away while still pausing at this point for the scan frame adjustment? I have found that it just slows down the workflow.

Thanks,
Mike

If you want to speed up and not see the message, don't use scanpilot.

That was so obvious, it was embarrassing! I don't know why I was so hung up on using ScanPilot.

Thanks for helping me see the forest in spite of the trees.

Mike