LaserSoft Imaging

Hello,

Please somebody explain to me what I'm doing wrong here. I have an OpticFilm 120 with Silverfast 8.8.0r8 Ai Studio.

I want to set up several frames from a 6x9 preview. Following the instructions in the Job Manager documentation, I do the following:

- Prescan
- set up the first frame

but then:

- Duplicate Frame not available, not even disabled in the Frame or Job Manager menus
- Command-D has no effect
- Click drag has no effect

What, if any, is the magic trick to define multiple frames, as shown in the documentation ?

Thanks
David

Dear David,

With your device you can only have one frame per image.
Multiple frames are only possible with flat bed scanners.


Kind regards,
Arne