LaserSoft Imaging

Hello,

I recently upgraded my Ai 5.5(with IT8) and HDR 5.5 to AI 6 and HDR 6.

I have no problem to use the IT8 calibration feature with the upgraded AI6.
However, when I try to setup "Scanner-Internal-Calibration" in HDR 6, It is
grayed out so I can't select it.

Also, There is no "Calibration profile" under "Embedded ICC Profiles" in HDR 6

When I upgraded my HDR 5.5 to the new HDR 6, I used the old HDR 5.5 serial number for it.

Should I have used the AI serial number with IT8 calibration for HDR6?

I though that I needed to use Ai serial number for Ai upgrade and HDR serial number for HDR upgrade.

Thank you,

HDR and using Calibration Profiles

In SilverFast HDR you can use the ICC-Calibration profiles you have generated with your SilverFast Ai IT8 calibration.
The item Calibration in HDR is only active when HDR is having the IT8-calibration option activated (so you would do the IT8-Calibration in HDR instead of your scanner SilverFast Ai).
What you would do to use calibration is either:

1. Embed the ICC-profile during the scan
You would then select: Scanner -->Internal:"Use embedded Profile" or

2. Allocate the previously in SF Ai generated ICC-profile in HDR
Select: Scanner -->Internal: ColorSync and
Select your ICC-scanner-profile under ->Profiles for ColorSync ->Scanner ...

??