LaserSoft Imaging

Hi,

In SF SE Plus, I have noticed that the on/off switches for the setting dialogs are not sticky over sessions. For example, I usually deactivate (uncheck) the Unsharp Masking feature but I keep the dialog displayed in the case I need it. When I re-launch SF, it is systematically re-activated. However, the specific settings for each feature are retained.

I would be nice it this problem could be fixed.

dear Samoreen,

thank you for your suggestion.
This is a known behavior. It is on the list of bugs that should be fixed.
In a further update it will be included.

Best regards
Artur Möller