IT-8 AUTO CALIBRATION

[gasp72]

Hi,
The IT-8 autocalibration is a suggested task to perform before any scan ?
If I deselct the autocalibration, the calibration would be manual?
After the grid have prescan the target film, the software open diaog box and ask me the refernce file.
I suppose the file must to have the same name on the target and I need to load the E090614.txt file, but I don't found it !

Thanks for your help

[LSI_Ketelhohn]

Hi,
The IT-8 autocalibration is a suggested task to perform before any scan ?

No only if temperature or humidity of your workplace change.
e.g.: Scanner moved to different room, Summer vs. Winter, etc.
Most users calibrate about every 1 to 3 months.

If I deselect the autocalibration, the calibration would be manual?

Yes, the steps performed automatically would have to be done manually.
This might be helpful if the scanner can not position the grid correctly.

After the grid have prescan the target film, the software open diaog box and ask me the refernce file.
I suppose the file must to have the same name on the target and I need to load the E090614.txt file, but I don't found it !

The reference file can be found on our homepage.


kind regards,
Arne Ketelhohn.

[gasp72]

Ok. Thanks for your fast reply

[LSI_Ketelhohn]

you're welcome.