I have a dual 1.2 mirror door 10.2.6, PS7, Microtek Scanmaker 9800XL and the SF 6.0.1r35.
I've reinstalled SF a few times, Wizard first, wizard not at all, etc. It works sometimes.
I'm using the standalone. The biggest problems are the settings I put in don't "stick";.
Then there's I/O problems? I can get a couple scans and then inexplicably the next one prescans fine, but there's apparently an IO error because the scan is corrupted (scanlines) when it's written to disk - or if I do the SDR I can see the scanlines. I've tried FIrewire and USB and it's the same deal.
Also, SF is trying to write or do something somewhere that causes it to quit with a Bad exception, Kernel Protection Failure error.
And, SF doesn't quit "gracefully" - it leaves invisible temp files, which must have the flags set wrong, because fsck finds them and deletes them.
I really like this software, is there a way to make it work on a consistent basis??
Also, any value in upgrading to the latest patch level - or is that not free either???
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest