Scanned image is different to the prescan frame (LS30/SF v5.

[wolke]

Hi again,

Has any other than me experienced, that the scanned image is a little different to the preview frame? I did a couple of positive slides with my LS30, and the preview frame was set very tight to the black dia frame. After scanning, i got a small stripe of the dia frame in the picture, allways on the lower side of the scanned picture! It looks as if the preview frame doesn?t match 100% the final scan. This mismatch was reproduceable multiple times, any idea about this problem?
System is Mac with PS 6.0 and Silverfast 5.5.1r08 and a Nikon LS30/coolscanIII.

regards
Wolfgang

<font size=-1>[ This Message was edited by: wolke on 2002-02-19 08:30 ]</font>

[LSI_Support]

Dear Wolfgang,
I hope you meet the "Nikon Maid conditions" these are:
- LS2000/LS30 must have firmware 1.31
- When NikonScan is installed alongside, must be ver. 2.51 or 3.1 not any older NikonScan version.
- make sure you install SilverFast AFTER NikonScan.

And as you are using SF ver 5.5.1r08, you are entitled to a free update to ver. 5.5.2

[wolke]

On 2002-02-27 10:57, LSI_support_Kohler wrote:
Dear Wolfgang,
I hope you meet the "Nikon Maid conditions" these are:
- LS2000/LS30 must have firmware 1.31
- When NikonScan is installed alongside, must be ver. 2.51 or 3.1 not any older NikonScan version.
- make sure you install SilverFast AFTER NikonScan.

And as you are using SF ver 5.5.1r08, you are entitled to a free update to ver. 5.5.2

Thank you for aswering my request!
I had a look at my SW and HW revisions and found out, that the Firmware is actually 1.31 but the NikonScan version is 2.1. Since i never had this problem with SilverFast 4.x, is it from the SF 5.5 version or better do i need the NikonScan program at all?
In other words, would it be better to remove the NikonScan SW and install SilverFast only?

once again thanks
Wolfgang

[LSI_Support]

with the LSIII and SilverFast 5.5 it is not necessary to install NikonScan SW.

[wolke]

Thank you!
That?s what i wanted to know.

friendly regards
Wolfgang