LS8000 and 5.5

[Guest]

I've bougth Silverfast 5.5 for my LS8000,
after installation, reboot, the system reports Scanner error code zero (0), during a single scan of a 35mm negative.The auto exposure and focusing are working, during scanning the progress window shows a mess instead of the picture. After this photoshop crashes. With nikonscan 3.1 there are no problems. Is there a pdf available that clarifies the error codes that the system returns ? I could not find anything on the CD. Milco.vanKlingeren@zonnet.nl

[Guest]

In the Nikonscan 3.1 software it is possible to switch between superfine and normal scanning mode on the LS8000. Is this possible in silverfast 5.5AI ? What is the default mode Silverfast uses?
The purpose of this function is to eliminate the "banding problem" on high-res medium format scans.
Milco.vanKlingeren@zonnet.nl.
By the way Silverfast is much faster in scanning as nikonscan !!!

[Andreas]

I had bad problems with scanner error 0 until very recently when I installed the latest version of 5.5. Now, these problems occur only very rarely anymore.

Bye

Andreas

[LSI_Support]

In the Nikonscan 3.1 software it is possible to switch between superfine and normal scanning mode on the LS8000. Is this possible in silverfast 5.5AI ? What is the default mode Silverfast uses?
The purpose of this function is to eliminate the "banding problem" on high-res medium format scans.
--Dear Anonymous,
the default with SilverFast is NOT the super fine scan mode. You can switch to this mode in SilverFast: Option > Special.