(1)+(2) The automatic image adjustment perhaps. Can't work if not the whole image is marked correctly. See (3)
(3) The two above might be a consequence of (3). To remedy, make sure you selected the correct settings for your film type and then use the film strip adjustment (further reading (0.7 Megs, PDF)).
(4) Calibration does not adjust negatives. Does this also occur if the film strip (cf. (3) above) is properly adjusted?
(5) Because you might lack the problem of (3).
- manager tech support, LSI AG -
All the problems with Microtek film scanners
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest