DNG file names

[Susan]

Hi,
I'm scanning family archives using DNG 48bit mode. Typical result was 8504 X 13451 file size when opened in Bridge to view. Suddenly today I am getting something like 5559 x 3360 @55ppi. Why is this adding the ppi that I did not designte. How do I go back to just the pixel dimensions? Is this a Bridge issue? I didn't change anything. Thanks, Susan

[LSI_Ketelhohn]

Dear Susan,

Please check the settings in SilverFast scan dimensions dialog.
The Value behind the @ would normally be the Preset.
Additionally you can check the exact output size in SIlverFast by opening the expert dialog (gear wheel symbol).
Set the measurement unit to pixel and the output field should show you the size of the created image.

Kind regards,
Arne