turning off auto-cor

[sebastianschubert]

is it possible to turn off the auto-correction after having selected a target area? when i've got a prescan of several negatives, and the active selection frame is looking good, i want to move the frame to the next slide, WITHOUT changing any levels or color settings. any hints?

(sf 6.5.0, epson v750)

[LSI_Noack]

Dear sebastianschubert

> Negafix dialogue > Expert mode > disable the "Auto" option.

Please note that the purpose of the imaging forum is not to provide personal support. It is intended to serve as a platform for imaging professionals for exchange of experience and communicating ideas [ viewtopic.php?p=9763&highlight=9763 ].
Therefore LSI staff will only provide limited support in the forum.
Thank you in anticipation of your kind co-operation.

Best regards
Sonny Noack
- Manager Technical Support, LaserSoft Imaging AG -

[JWD]

Is it considered 'forbidden' to ask for help from other users? Every online forum on a specific topic like this (i.e. silverfast sw) that I've ever seen is full of people trying to help eachother. I think this person's post is very typical... if we are not allowed to request help from other users... is there another forum we can go to for help with your software? I want to like silverfast - but it has a LOT of problems (esp. in terms of ergonomics and defaults - not the most intuitive sw)... but there really needs to be a place where people can get help for topics that aren't covered in the manual...