1. I wish that before the final scan, when the end result of all my editing is done, I could preview the final product before taking the time to save it.
2. When removing dust and scratches, I wish I was not restricted by the areas that are marked in the preview window... that is, I wish I would select more than one at a time and I wish I could apply a mask across several of them at the same time.
3. When removing dust and scratches, I wish that I could point to a red line or spot and turn it green or point to a green spot or line and turn it red. The existing functions to a great job but sometimes the make bad choices. e.g. A wive will be seen as a scratch. If I change the setting so that this does not happen, scratches are not seen as defects.
I wish there was a way to give these suggestion to the programmers of at LaserSoft
