Silverfast 6 Workflow Question

[ianders1]

After looking at the new SF6 manual, I have a question about the workflow chart on page 17. Where in the workflow should one use the new SRD feature? I assume that it should be before or after #6, Dust and Scratch Removal. Is this correct? I just want to make sure I'm using SF6 to it's maximum potential.

Thanks,
Ian A.

[LSI_Support]

Dear Ianders1,
the SRD is the dust scratch removal function.

[ianders1]

Engelhardt,

I must've been half-asleep when I posted that - I meant to say when should I set the GANE setting?

Thanks,
Ian A.

[President_LSI]

Workflow for SilverFast SRD

Basically SRD should be used after scaling and sharpness has been set, since especially the sharpness function would affect the visibility of dust and scratches!

[ilyons]

Workflow for SilverFast SRD

Basically SRD should be used after scaling and sharpness has been set, since especially the sharpness function would affect the visibility of dust and scratches!

I don't think that this was the answer IanA was looking for. However, given that you imply that the filters should be applied before SRD I think we can take it that GANE should be applied before SRD. It sure looks like SilverFast does the GANE processing before SRD.

IanL