ScanPilot-"Draw desired scan frame...." dialog box

[mhgreene]

I have the "Set Parameters for Scan-Frame" box checked in the Pref for ScanPilot.

I initiate the pre-scan using ScanPilot. The second step pauses to allow me to adjust the size of the scan which is great . However, then an annoying dialog box pops ups titled "Note" with the contents reading "After closing this alert, draw your desired scan frame.......". Is there a way to make this dialog box go away while still pausing at this point for the scan frame adjustment? I have found that it just slows down the workflow.

Thanks,
Mike

[degrub]

If you want to speed up and not see the message, don't use scanpilot.

[mhgreene]

That was so obvious, it was embarrassing! I don't know why I was so hung up on using ScanPilot.

Thanks for helping me see the forest in spite of the trees.

Mike