RPS 7200 full optical resolution


xtolsniffer
Visitor
Posts: 6
Joined: Mon Oct 07, 2013 9:07 am
Scanner: Epson V700
Reflecta RPS 7200
SilverFast Product: Ai Studio

RPS 7200 full optical resolution

Postby xtolsniffer » Wed Oct 09, 2013 12:29 pm

I'm using a Reflacta RPS 7200 with Silverfast SE Plus ver. 8.
When I scan normally, I can select resolutions up to 7200 ppi which is supposed to be the maximum optical resolution of the scanner. But if I start with the workflow pilot it will only allow me to select up to 3600 ppi as the 'maximum optical resolution'. Is there something odd about this scanner and the optical resolution?
Also, whenever I launch Silverfast and then either insert a film strip or a mounted slide, I get a dialogue box that says 'loading holder, silverfast will now restart' and I have to click ok and then relaunch it.

Dean

User avatar
LSI_Ketelhohn
LSI Staff
LSI Staff
Posts: 4265
Joined: Wed May 28, 2008 11:19 am
Scanner: all
Location: Kiel, Germany
Contact:

Re: RPS 7200 full optical resolution

Postby LSI_Ketelhohn » Fri Oct 11, 2013 9:06 am

Dear Dean,

In the Workflow Pilot the available settings can be limited.
The resolutions offered depend on the workflow you are going to use.

In normal scanmode there are no limitations.
The resolution slider allows all resolutions offered by the scanner's driver.
The yellow resolution setting is the last optical resolution.
Additionally an interpolated resolution is offered as the "red" value.
This is the last and rightmost setting.


Kind regards,
Arne Ketelhohn.


Return to “Reflecta”

Who is online

Users browsing this forum: No registered users and 4 guests